3 Amazing Vises in One.
Your GMV Vise is (3) three vises in one.
It starts out as a Double Vise.
It can convert into a Single Station Vise.
It can convert into a Reversed Single Vise.
The 6.0-inch "GMV-EAGLE" Modular Vise
Transform your GMV Vise in seconds.
Double Station Mode3.5" capacity in each station with slim jaw plates (3.25" standard)
- Clamp two work-pieces simultaneously.
- Adjustable friction stop allows sequential jaw movement.
- Anti jaw-lift wedge mechanism.
- Bed and jaw plates hardened to HRC 50-60.
- Over 10,000 lbs of clamping force.
Single Station Mode11.0" capacity with slim jaw plates (10.5" standard)
- Converts to single station mode without any additional hardware.
- Static footprint, nothing protrudes outside of the vise.
- Anti jaw-lift wedge mechanism.
- Bed and jaw plates hardened to HRC 50-60.
- Over 10,000 lbs of clamping force.
Reversed Mode11.0" capacity with slim jaw plates (10.5" standard)
- Converts to reversed station mode without any additional hardware.
- Static footprint, nothing protrudes outside of the vise.
- Anti jaw-lift wedge mechanism.
- Bed and jaw plates hardened to HRC 50-60.
- Over 10,000 lbs of clamping force.
Indexable Center Jaw
5 Possible Jaw Configurations.
The GMV comes with an indexable Center Jaw, giving the user five distinct vise jaw combinations, and three fixed-jaw configurations. Use round head pins or diamond pins and make adjustments to your setup in mere seconds.
The 5 Second
Rapid Release Jaws
Are you spending too much time switching jaws on your vise?
Does it take minutes to change between hard jaws, soft jaws, vee jaws, and custom jaw plates?
Glacern Rapid Release Jaws are the solution.
With a single twist of an allen wrench your vise jaws are now removable.
Our jaws use the industry standard bolt pattern 3.875" x 0.9375" and locate precisely
with a removable pin. Install your Rapid Release jaw plates in seconds. It's that simple.
(Slim Rapid Release Jaws also available as an optional accessory)
Unequivocally Accurate
Multiple Locating Options.
Locating pins are used for controlled, fine tolerance position of a work piece. Usually two locating pins properly locate the work piece on one plane. The Glacern Modular Vise uses this concept to attach jaws to the vise bed. A diamond pin is also an available accessory, and you can optionally use it (instead of one of the round head pins) to make attaching the jaws to the bed significantly smoother.